Sliding barn door for closet – Animal stalls are different sizes depending on the type of animal for which are built. Examples are horse stables, stalls milking cow and goat birthing positions. Stall doors vary in shape, size and type of construction based on the type of animal that is limited and designated use of the cabin. Here is a step by step guide to building Dutch doors for a horse stable. Sliding barn door for closet are a two doors where the door is located above the other.
Measure the width and height of the area where the sliding barn door for closet will be installed. Using these measurements to calculate the required length and width for each door. Leave 1 1/2 inch gaps between the upper and lower doors, between the lower door and the floor and between the upper door and any rafters or other construction above it. In determining the width, allowing the door hinges and latch. Saw two 2-inches by 6-inch boards with a length that matches the width of the upper sliding barn door for closet. Place these plates horizontally on a work area far enough apart in distance from the top edge of the top panel to the bottom edge of the bottom panel is equal to the height of the door. Cut two additional 2-inches by 6-inch boards in a length to fit between the horizontal joints.
Place a second 2 6 via the other two corners of the frame and mark the place where he will be sawn. Also check this board by running the pencil ticking along both edges of the installed at its intersection key. Instead of one piece, the clamp consists of two parts. We saw two tables and attach to the plywood. Ask a lower door in the same way you did the top door. The only exception is that the lower panel this door is a 2 x 8 rather than 2 6. Hang the doors on the doorposts using two heavy hinges on each door. Install bolt locks on both sliding barn door for closet.