Garage screen doors – Correcting the problem requires straightening screen door to its original form with an adjustable tow bar and rod support kit. You can fix the screen door with the right tools, the right materials and a basic home improvement skills. Measure distance diagonally from the upper corner of the screen door to the lower corner by means of a measuring tape.
Put a rod support bracket to each corner on the inside of the garage screen doors with the supplied screws and a screwdriver. Set one of the threaded ends of a rod into the hole in the top corner fittings. Place locking nut on the other end of the rod and turn it clockwise until the rod end is visible on the inside of the turnbuckle. Install rod remaining in the bottom bracket hole and make it to the other end of the clamping nut.
Connect a nut to the bracket end of the rod and tighten it by hand. Tighten the nut on the pole on the top bracket by hand. Set the upper and lower nuts just until the rods and locking nut is snug. Close the screen door slightly until it binds. Turn the clamping nut clockwise with a flat-head screwdriver. Repeat step 10 with a half-turn of the turnbuckle until the garage screen doors closes properly.